You can go to variable to the 12-digit HEX address of your watch (press button D (bottom-left), the address is the xxxx-xxxx-xxxx formatted number at the bottom).
After uploading the code, open up the serial monitor (set at 9600 bps).
I then tried the console (very handy btw) to switch to tcpip for adb directly on the phone - again no errors, seemed to work, except still the same error on the PC side. Here is the code and here the plugin ready to be used. Here you have a gif: Root IS needed to change that system properties. You can forward the ports while connected through USB and then tell the adb daemon to listen over a certain frequency: ADB over wirless I've encoutered the same problem, and my device was rooted. If you installed adbd Insecure on your device, it will prevent you from connecting to your device via Wi Fi.
Canon printers are among the best on the market today for photo printing; the high-end ones print at significantly higher resolutions than the next-best competitor.
Hooking up one of these machines to your computer will take virtually no time at all.
All new units since June 2014 have the firmware correction in place.
We should mention that this has only been reported as an issue with the Apollo and other units seem to recover the data either way with no sync issues, so it did not appear even in our very thorough production test jigs.
With an Apollo Twin - where no BNC wordclock output is available - you would have to slave the Apollo using the ASP880 as master with clock over ADAT and thus no issues will be experienced in this config either, on all firmware versions.